Part Number |
MBD-X7DAE+-O |
X7DAE+-O |
Physical Stats |
Form Factor |
Extended ATX |
Dimensions |
12" x 13.05" (30.5cm x 33.2cm) |
Processor/Cache |
CPU |
Dual 771-pin LGA Sockets
Supports up to two Intel® 64-bit Xeon® processor(s)
of the same type below:
- Quad-Core Intel®
Xeon®Processor 5300 sequence (Clovertown processor) up to 2.66 GHz
- Dual-Core Intel®
Xeon®Processor 5100/5000 sequence (Woodcrest/Dempsey processor) up
to 3.73 GHz
|
System
Bus |
1333 MHz, 1066 & 667 MHz system bus |
System Memory |
Memory
Capacity |
Eight 240-pin DIMM sockets
Supports up to 32 GB 667 / 533MHz DDR2 ECC
FB-DIMM memory
Dual branch memory bus
Memory must be populated in pairs
Memory Mirroring supported
|
Memory
Type |
667 /
533MHz FB-DIMM (Fully Buffered DIMM) DDR2 ECC SDRAM 72-bit,
240-pin gold-plated DIMMs |
DIMM Sizes |
512 MB, 1GB, 2GB, 4GB |
Memory
Voltage |
1.8 V only
1.5V(AMB)
|
Error
Detection |
Corrects single-bit errors
Detects double-bit errors (using ECC memory)
Supports Intel® x4 and x8 Single Device
Data Correction (SDDC)
|
On-Board Devices |
Chipset |
Intel® 5000X (GreenCreek) chipset
MCH + PXH-V + ESB2
|
SATA |
Intel ESB2 SATAII Controller
RAID 0, 1, 5, 10 support (Windows)
RAID 0, 1, 10 support (Linux)
|
IPMI |
Support for Intelligent Platform
Management Interface v.2.0
200-pin IPMI slot (SIMLP)
( Optional: AOC-SIMLP-B )
( Optional: AOC-SIMLP-3 ) with
3rd LAN support
NOTE: KVM-over-LAN not supported
- there is no DVO signal to the
IPMI slot
|
Network
Controllers |
Intel® (ESB2/Gilgal) 82563EB Dual-Port Gigabit
Ethernet Controller
Supports 10BASE-T, 100BASE-TX, and 1000BASE-T,
RJ45 output
Intel® I/OAT support for fast, scaleable,
and reliable networking
|
Clock
Generator |
CK410B chip |
Super
I/O |
Winbond 83627HG chip |
Input / Output |
Serial
ATA |
Six Serial ATA ports
Six SATA hard drives supported
|
IDE |
Single EIDE channel supports up to
two UDMA IDE devices(IDE-M, IDE-S)
including CF card
Supports UDMA Mode 5, PIO Mode 4,
and ATA/100
Compact Flash (40-pin connector,
IDE 1, single channel) slot
|
Floppy |
1 Floppy
controller; 1.44 MB, 2.88 MB |
LAN |
2x RJ45
LAN ports |
USB |
4x USB rear ports
1x USB internal header
6 total USB ports, 2.0 Compliant
/ 1.1 Compliant
|
Audio |
7.1 High Definition audio |
Keyboard
/ Mouse |
• PS/2
keyboard and mouse ports |
Serial
Port / Header |
1 Fast
UART 16550 serial port |
Chassis ( Optimized for
X7DAE+
) |
2U
Chassis |
CSE-825TQ-R700LPV
CSE-825TQ-560LPV
CSE-823T-550LP
CSE-823i-550LP
|
Tower
/ 4U Rackmount |
CSE-743T-645 (FAN-0091 Required)
CSE-743i-645 (FAN-0091 Required)
|
Important
Chassis Notes |
To
ensure system stability, a 500W (minimum) ATX power
supply
[4-pin (+12V), 8-pin (+12V) and 24-pin are required] |
Expansion Slots |
PCI-Express |
1 (x16) PCI-e slot
1 (x4) PCI-e (using x16) slot
|
PCI-X |
2x 64-bit 133/100MHz PCI-X (3.3V)
slots
1x 64-bit 100MHz PCI-X (3.3V)
slot
|
PCI |
1x 32-bit 33MHz PCI (5 V) slots
|
System BIOS |
BIOS
Type |
8Mb
Flash EEPROM with Phoenix® BIOS |
BIOS
Features |
Plug and Play (PnP)
SMBIOS 2.3
DMI 2.1
PCI 2.2
ACPI 1.0
PCI-X 1.0
USB Keyboard support
Hardware BIOS Virus protection
|
Management |
Software |
Super Doctor
III
Watch Dog
NMI
Optional IPMI (Intelligent Platform
Management Interface) v2.0 |
Power
Configurations |
ACPI Power Management
Wake-On-Ring (WOR) header
Wake-On-LAN (WOL) header
Power-on mode for AC power recovery
Internal/External modem remote
ring-on
Suspend to RAM (STR)
|
PC Health Monitoring |
CPU |
Monitors for CPU
Cores, +1.8V, +3.3V,
+5V, -12V & +5V
Standby, VBAT
CPU Core 5-Phase-switching
voltage regulator with
auto-sense from 0.8375V-1.60V
|
FAN |
Total of eight 4-pin
fans
8x fans with status
monitoring
Status monitor for
speed control
Support 3-pin fans
Low noise fan speed
control
Pulse Width Modulated
(PWM) fan connectors
|
Temperature |
Monitoring for CPU
and chassis, environment
CPU thermal trip
support
PSU I 2 C temperature
sensing logic
Thermal Monitor 2
(TM2) support
|
LED |
CPU / System Overheat LED |
Other
Features |
Chassis intrusion detection
Chassis intrusion header |