| Model
|
| Brand
|
Supermicro |
| SYS-7045W-NTR+ |
SYS-7045W-NTR+ (Beige) |
| Motherboard |
| Motherboard |
Super X7DWN+ |
| Processor/Cache |
| CPU |
Dual 771-pin LGA Sockets
Supports up to two Intel® 64-bit Xeon® processor(s) of the same type below:
- Quad-Core Intel®
Xeon®Processor
5400/5300 sequence
(Harpertown
/Clovertown processor)
up to 3.16 GHz
- Dual-Core Intel®
Xeon®Processor 5200/5100/5000
sequence (Wolfdale
/Woodcrest/Dempsey processor) up to 3.40 GHz
|
| System Bus |
1600 / 1333 / 1066 MHz system bus |
| System Memory |
| Memory Capacity |
Sixteen 240-pin DIMM sockets
Supports up to 128 GB 800 / 667 / 533MHz DDR2 ECC FB-DIMM memory
Dual branch memory bus
Memory must be populated in pairs
Memory Sparing supported
|
| Memory Type |
800 / 667 / 533MHz FB-DIMM (Fully Buffered DIMM) ECC DDR2 SDRAM 72-bit, 240-pin gold-plated DIMMs |
| DIMM Sizes |
512 MB, 1GB, 2GB, 4GB , 8GB** |
| Memory Voltage |
1.8 V or 1.5 V |
| Error Detection |
rects single-bit errors
Detects double-bit errors (using ECC memory)
Supports Intel® x4 and x8 Single Device Data Correction (SDDC)
|
| On-Board Devices |
| Chipset |
Intel® 5400 (Seaburg) chipset
ESB2
|
| SATA |
- Intel ESB2 SATA 3.0Gbps Controller
- RAID 0, 1, 5, 10 support (Wondows only)
|
| IPMI |
Support for Intelligent Platform Management Interface v.2.0 / 1.5
200-pin IPMI slot (SIMSO(+))
|
| Network Controllers |
Intel® 82575 Dual-Port Gigabit Ethernet Controller
Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
Intel® I/OAT support for fast, scaleable, and reliable networking
|
| Graphics |
ATI ES1000 controller with 32 MB of video memory |
| Super I/O |
Winbond 83627HG chip
|
| System BIOS |
| BIOS Type |
8Mb Flash EEPROM with Phoenix® BIOS
EFI BIOS Support
|
| BIOS Features |
Plug and Play (PnP)
DMI 2.3
PCI 2.2
ACPI 1.0 / 2.0
USB Keyboard support
SMBIOS 2.3
|
| Dimensions
|
| Dimensions (H x W x D) |
7.0" x 17.2" x 25.5" |
| Front Panel
|
| Buttons |
Power On/Off button
System Reset button |
| LEDs |
Power LED
Hard drive activity LED
2x Network activity LEDs
System Overheat / Fan Fail LED
Power Fail LED
|
| Ports |
2x USB Ports |
| Drive Bays |
| Hot-swap |
3x 2.5" SAS/SATA Hot-swap drive bays |
| Input / Output |
| Serial ATA |
Six Serial ATA ports
Six SATA hard drives supported
|
| IDE |
Single EIDE channel supports up to two UDMA IDE devices (IDE-M, IDE-S) including CF(Compact Flash) Card
Compact Flash (40-pin connector, IDE 1, single channel) slot
Supports UDMA Mode 5, PIO Mode 4, and ATA/100
|
| Floppy |
1 Floppy controller; 1.44 MB
|
| LAN |
2x RJ45 LAN ports
|
| USB |
2x USB rear ports
3x USB internal headers
Total 5 USB 2.0 Compliant / 1.1 Compliant
|
| VGA |
1x VGA Port
|
| Serial Port / Header |
1 Fast UART 16550 serial port
1 Serial header
|
| Operating Environment / Compliance |
| Environmental Spec. |
Operating Temperature: 10°to 35°C (50°to 95°F)
Non-operating Temperature: -40°to 70°C (-40°to 158°F)
Operating Relative Humidity: 8% to 90% (non-condensing)
Non-operating Relative Humidity: 5 to 95% (non-condensing) |
