Product SKUs |
SYS-2026GT-TRF | SuperServer 2026GT-TRF (Black) |
Motherboards |
Motherboards | X8DTG-QF+ |
Processor/Cache |
CPU Type | Dual 1366-pin LGA Sockets Supports up to two Intel® 64-bit Xeon® processor(s) of the same type below: Intel® Xeon® Processor X5600/E5600/L5600 Series (Westmere) 40W - 130W Intel® Xeon® Processor X5500/E5500/L5500 Series (Nehalem-EP) 38W - 95W |
QPI | up to 6.4 GT/s |
System Memory |
Memory Capacity | 6x 240-pin DIMM sockets Supports up to 96 GB 1333 / 1066 / 800MHz DDR3 ECC Registered memory Memory Mirroring supported |
Memory Type | 1333 / 1066 / 800MHz ECC Registered DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs |
DIMM Sizes | 1GB, 2GB, 4GB , 8GB , 16GB |
Memory Voltage | 1.5 V / 1.35V |
Error Detection | Corrects single-bit errors Detects double-bit errors (using ECC memory) Supports Intel® x4 and x8 Single Device Data Correction (SDDC) |
On-Board Devices |
GPU | Supports 4 GPU Cards such as NVIDIA Fermi M2090, M2070, M2050 |
Chipset | Dual Intel® 5520 (Tylersburg) chipset + PLX 8647 + ICH10R |
SATA | Intel ICH10R SATA 3.0Gbps Controller RAID 0, 1, 5, 10 support |
IPMI | Support for Intelligent Platform Management Interface v.2.0 IPMI 2.0 with virtual media over LAN and KVM-over-LAN support Winbond® WPCM450 BMC |
Network Controllers | Intel® 82576 Dual-Port GbE Controller Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output Intel® I/OAT 3 support for fast, scaleable, and reliable networking VMDq support for better performance of virtualization 1x Realtek RTL8201N PHY (dedicated IPMI) |
Graphics | Matrox G200eW 16 MB DDR2 |
Super I/O | Winbond W83527HG chip |
Clock Generator | 932S421 chip |
Input / Output |
Serial ATA | 6 Serial ATA ports 6 SATA hard drives supported |
LAN | 2x RJ45 LAN ports 1x RJ45 Dedicated IPMI LAN port |
USB | 2 rear USB 2.0 ports |
Serial Port | 1 Serial header |
Video | 1 VGA Connector |
Chassis |
Form Factor | 2U Rackmount |
Model | CSE-218G-R1800B |
Front Panel |
Buttons | Power On/Off button System Reset button |
LED | Power LED Hard drive activity LED 2x Network activity LEDs System Overheat LED / Fan fail LED /UID LED |
Expansion Slots |
PCI-Express | 4 PCI-E 2.0 (x16), full-height full-length(support any double width cards) 1 PCI-E 2.0 (x8), full-height full-length 2 PCI-E 1.0 (x4), full-height full-length 1 PCI-E 2.0 (x8), low-profile via riser card |
Drive Bays |
Hot-swap | 10x 2.5" Hot-swap SATA drive bays(4 spares) |
Backplane |
Backplane | SAS/SATA HDD Backplane(SAS support requires optional SAS controller) |
System Cooling |
Fans | 5x 8cm heavy-duty fans with optimal fan speed control |
Power Supply |
Power Supply | 1800W (1+1) Redundant 1800W power supply with PMBus |
AC Input | 100-240 V, 50-60 Hz, 12-8.5 Amp |
DC Output | 4 Amp @ +5V standby 150 Amp @ +12V |
With a Popular Power Distributor | +5V: 30 Amp +3.3V: 24 Amp -12V: 0.6 Amp |
Certification | 80PLUS |